Bantam BC8HP Instructions d'exploitation télécharger pdf (Page 10)

STATION

Lithium battery (LiIo/LiPo/LiFe) program

These programs are only suitable for charging and discharging

Lithium batteries with a nominal voltage of 3.3V, 3.6V or 3.7V per

cell. These batteries need to adopt different charge technique is

termed constant voltage(CV) and constant current (CC) method.

The charge current varies according to the battery capacity and

performance. The final voltage of charge process is also very

important, it should be precisely matched with the charged

voltage of the battery. They are 4.2V for LiPo, 4.1V for LiIo and

3.6V for LiFe. The charge current and nominal voltage as for cell-count set on the charge program must

always be matched with the battery being charged.

Select the output channel that the program will be performed by pressing ‘CHANNEL’ button. Then, select

one of the program which suits the type of battery being processed using UP/DOWN’ button and press

‘START/ENTER’ button to enter the program.

Charging Lithium battery (LiIo/LiPo/LiFe)

PROGRAM SELECT

CH2>

LiPo

LiFe

LiIo

NiMH

NiCd

SETUP

REVIEW

Chg curr : 5.0A

Chg mode : Normal

End curr : Auto

Chk time : 10min

Max capa : 100%

LiPo[ 1 ] 6S(22.2V)

3000mAh CHARGE

▶

- Charge current : Set the charge current. (0.1 ~ 9.0A)

Chg curr : 5.0A

Chg mode : Normal

End curr : Auto

Chk time : 10min

Max capa : 100%

LiPo[ 1 ] 6S(22.2V)

3000mAh CHARGE

You can choose a sub-program to be performed by pressing

‘MODE’ button, there are ‘CHARGE’, ‘DISCHARGE’ and

‘STORAGE’ programs. And then select the data number which

will newly set up, or load the data number already set up for

re-use using ‘INC’ or ‘DEC’ buttons. If you have the set-up data

which had been performed successfully before, you can just start

the process after loading the data number. All setup data will be

stored at charger’s memory automatically after setting them all.

Input the cell-count and capacity of the battery will be charged.

The cell-count and capacity need to be matched with the battery.

Use ‘UP/DOWN’ buttons to scroll up and down the menu, and

change the value using ‘INC/DEC’ buttons when the pertinent

field is blinking.

To start the process, press and hold ‘START/ENTER’ button for

more than 3 seconds regardless of cursor position.

Set : 6S(22.2V)

Read : 6S(22.2V)

LiPo[ 1 ] 6S(22.2V)

3000mAh CHARGE

▶

Confirm(ENTER)

This shows the number of cells you set up and the charger

detects. 'Read' shows the cell-count found by the charger and

'Set' is the number of cells selected by you at the previous

screen. If both numbers are identical you can start charging by

press ‘START/ENTER’ button. If not, press ‘STOP/ESC’ button

to go back to previous screen. Then carefully check the number

of cells of the battery pack again.

- 10 -

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Bantam BC8HP Instructions d'exploitation Page 10

Commentaires sur ces manuels