Bantam BC8HP Instructions d'exploitation télécharger pdf (Page 20)

STATION

- 20 -

▶

Review the data after finishing the process

(1) Output voltage : Shows the DC voltage at the output on end of

process.

(2) Charged or discharged capacity

(3) Time : Records the amount of time in minutes, which needed

to complete the process, not counting the time in trickle charge.

(4) Output channel mark : The output channel which the process

had been performed.

(5) The graph shows the voltage curves in Y-axis along with the

time in X-axis, after the process has finished.

UP/DOWNUP/DOWN

After finishing the program, you can review the data which

had been pertained to the input and output of the charger by

selecting menu at the main screen.

These data can not be shown while the program is being on

process.

The display shows the final voltage of individual cells, when the

balance tab was connected to the individual port of charger

during the process of Lixx battery. ith balance mode.

DAT GRP CYE CEL

10.54V 898mAh 52m

▶

DAT GRP CYE CEL

Input vol : 12.35V

Output vol : 10.54V

Ext. temp : 42C

Chg time : 52min

Dchg time : 0min

Capacity : 898mAh

▶

DAT GRP CYE CEL

No Capacity Voltage

1 C 00000mAh 0.00V

D 00000mAh 0.00V

2 C 00000mAh 0.00V

D 00000mAh 0.00V

▶

DAT GRP CYE CEL

No Vol No Vol

UP/DOWNUP/DOWN

PROGRAM SELECT

CH2>

LiPo

LiFe

LiIo

NiMH

NiCd

SETUP

REVIEW

Input vol : DC voltage at the charger’s input lead.

Output vol : DC voltage of battery at the end of process.

Ext. temp. : The temperature of battery as measured with

temperature sensor connected to temp. port of charger at the end

of process.

CHG time : The total amount of time needed to complete charge

process.

DCHG time : The total amount of time needed to complete

discharge process.

Capacity : The total amount of charged or discharged capacity for

whole process.

This display shows the battery’s capacity and peak voltage

readings for each charge and discharge period for up to 10

cycles. The cycle number is show on the left side of the display.

Pressing ‘INC’ or ‘DEC’ button will scroll the display up and down.

Charge data is marked by ‘C’ and discharge data is marked by

‘D’.

C1: 4.20V C5: 0.00V

C2: 4.19V C6: 0.00V

C3: 4.20V C7: 0.00V

C4: 0.00V C8: 0.00V

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Bantam BC8HP Instructions d'exploitation Page 20

Commentaires sur ces manuels